GATE ME 2026 Set 1 — Question 32
Go beyond PYQs with Success TrackerAI-powered personalised practice and doubt support. Unlimited practice on eligible plans; AI usage limits apply.MCQ+1 / -0.33MediumJigs & FixturesCNC & Work HoldingManufacturing Processes
Manufacturing Processes → CNC & Work Holding → Jigs & Fixtures
Last updated
Question
A work piece is to be firmly held in a fixture. It is to be machined by using a plain slab milling cutter as shown in the figure below.Which one of the following options is the most suitable value of height of the fixture in mm?
Figure not to scale
Correct answer
(A) 200
Solution
The workpiece height is 205 mm. To machine the top surface using a slab milling cutter, the fixture height must be less than the workpiece height to ensure the cutter does not collide with the fixture. To provide maximum stability and support, should be as close to the workpiece height as possible while maintaining clearance.
- mm: Higher than the workpiece, causing collision.
- mm: Provides 5 mm clearance and maximum support.
- mm or mm: Provides clearance but significantly less support.
Continue learning with Success Tracker
A step still unclear? Work through it with support
Use Success Tracker to ask about the reasoning, then try another GATE ME question to check your understanding.
AI-powered practice· Unlimited practice on eligible plans
- PYQs with solutions
- Attempt available previous-year questions, then compare your reasoning with the worked solution. Coverage varies by stream.
- Practice that adapts
- Choose a topic, work on weaker areas and bookmark questions to revisit. Your attempts feed your progress tracking.
- AI doubt support
- Ask follow-up questions about a step or concept while practising, instead of stopping at the final answer.
Unlimited practice is available on eligible plans. Free practice and AI usage have limits; check the current plan allowances before choosing.
This page stays readable without an account. AI responses can be wrong; check them against the solution and source material.
More questions on CNC & Work Holding
2026 Set 1 Q30In relation to metal casting defects, match the following | Defect | Description | | :--- | :--- |…2026 Set 1 Q59In a deep drawing operation of a rectangular sheet metal, stretching in length results in…2026 Set 1 Q63During orthogonal turning by using a single point cutting tool, feed rate is 0.24 mm/rev. The uncut…2026 Set 1 Q64A drill bit during its lifetime can produce 150 through holes in a plate at a drill-speed of 200…2025 Set 1 Q21The welding process commonly used for fabricating tailor-welded blanks of dissimilar thickness for…