Success TrackerSuccess Tracker
Log inSign up

GATE EC 2020 Set 1 — Question 27

Go beyond PYQs with Success TrackerAI-powered personalised practice and doubt support. Unlimited practice on eligible plans; AI usage limits apply.
NAT+1 / -0MediumClamping CircuitsDiode CircuitsAnalog CircuitsHW, FW & Bridge Rectifiers

Analog Circuits → Diode Circuits → Clamping Circuits

Last updated

Question

In the circuit shown below, all the components are ideal and the input voltage is sinusoidal with an rms value of 230230 V. The magnitude of the steady-state output VoV_o (rounded off to two decimal places) is ______ V.
A half-wave voltage doubler circuit with input 230 V (rms), two diodes D1 and D2, and two capacitors C1 and C2 of 0.1 microfarad each
Your answer

Enter a number. Decimals, negative values and scientific notation are accepted.

The solution stays hidden until you check.

Continue learning with Success Tracker

A step still unclear? Work through it with support

Use Success Tracker to ask about the reasoning, then try another GATE EC question to check your understanding.

AI-powered practice· Unlimited practice on eligible plans
PYQs with solutions
Attempt available previous-year questions, then compare your reasoning with the worked solution. Coverage varies by stream.
Practice that adapts
Choose a topic, work on weaker areas and bookmark questions to revisit. Your attempts feed your progress tracking.
AI doubt support
Ask follow-up questions about a step or concept while practising, instead of stopping at the final answer.

Unlimited practice is available on eligible plans. Free practice and AI usage have limits; check the current plan allowances before choosing.

Start with a free accountView plans and allowances

This page stays readable without an account. AI responses can be wrong; check them against the solution and source material.

More questions on Diode Circuits

2026 Set 1 Q17The ideal OP-AMP circuit shown in the Figure produces output voltage Vo=xV_o = x when the Switch, S,…2026 Set 1 Q18Consider the circuit shown in the Figure with Vi=3 VV_i = 3\text{ V} and VCC=12 VV_{CC} = 12\text{ V}. Assume…2026 Set 1 Q50A small signal source, Vi(t)=Acos⁡(105t)+Bsin⁡(107t)V_i(t) = A \cos(10^5 t) + B \sin(10^7 t) is applied to a BJT circuit as…2026 Set 1 Q53A circuit using an ideal OP-AMP is shown in the Figure. Which of the following options gives the…2026 Set 1 Q60An nn-channel MOSFET is connected as shown in the Figure. Assume VTH=1 VV_{TH} = 1\text{ V},…