GATE ME 2014 Set 2 — Question 62
Go beyond PYQs with Success TrackerAI-powered personalised practice and doubt support. Unlimited practice on eligible plans; AI usage limits apply.MCQ+2 / -0.67EasyCNC Programming (G & M Codes)CNC & Work HoldingManufacturing Processes
Manufacturing Processes → CNC & Work Holding → CNC Programming (G & M Codes)
Last updated
Question
For the CNC part programming, match Group A with Group B:
| Group A | Group B |
|---|---|
| P: circular interpolation, counter clock wise | I: G02 |
| Q: dwell | II: G03 |
| R: circular interpolation, clock wise | III: G04 |
| S: point to point countering | IV: G00 |
Correct answer
(A) P-II, Q-III, R-I, S-IV
Solution
In CNC programming, the standard G-codes are:
- G00: Rapid positioning (Point-to-point) S-IV
- G02: Circular interpolation Clockwise (CW) R-I
- G03: Circular interpolation Counter-clockwise (CCW) P-II
- G04: Dwell Q-III
Continue learning with Success Tracker
A step still unclear? Work through it with support
Use Success Tracker to ask about the reasoning, then try another GATE ME question to check your understanding.
AI-powered practice· Unlimited practice on eligible plans
- PYQs with solutions
- Attempt available previous-year questions, then compare your reasoning with the worked solution. Coverage varies by stream.
- Practice that adapts
- Choose a topic, work on weaker areas and bookmark questions to revisit. Your attempts feed your progress tracking.
- AI doubt support
- Ask follow-up questions about a step or concept while practising, instead of stopping at the final answer.
Unlimited practice is available on eligible plans. Free practice and AI usage have limits; check the current plan allowances before choosing.
This page stays readable without an account. AI responses can be wrong; check them against the solution and source material.
More questions on CNC & Work Holding
2026 Set 1 Q30In relation to metal casting defects, match the following | Defect | Description | | :--- | :--- |…2026 Set 1 Q32A work piece is to be firmly held in a fixture. It is to be machined by using a plain slab milling…2026 Set 1 Q59In a deep drawing operation of a rectangular sheet metal, stretching in length results in…2026 Set 1 Q63During orthogonal turning by using a single point cutting tool, feed rate is 0.24 mm/rev. The uncut…2026 Set 1 Q64A drill bit during its lifetime can produce 150 through holes in a plate at a drill-speed of 200…