GATE ME 2018 Set 1 — Question 35
Go beyond PYQs with Success TrackerAI-powered personalised practice and doubt support. Unlimited practice on eligible plans; AI usage limits apply.NAT+1 / -0MediumLinear & Angular MeasurementMetrology & InspectionMetrology, CIM & Additive Mfg
Metrology, CIM & Additive Mfg → Metrology & Inspection → Linear & Angular Measurement
Last updated
Question
The height (in mm) for a 125 mm sine bar to measure a taper of on a flat work piece is _______ (correct to three decimal places).
Correct answer
57 to 58
Solution
Given:
Length of the sine bar, mm
Taper angle, To find the height of the slip gauges ():
Length of the sine bar, mm
Taper angle, To find the height of the slip gauges ():
1.Convert the angle from degrees and minutes to decimal degrees:
2.Use the sine bar formula:
3.Rounding to three decimal places as requested:
The official answer range provided is to .Continue learning with Success Tracker
A step still unclear? Work through it with support
Use Success Tracker to ask about the reasoning, then try another GATE ME question to check your understanding.
AI-powered practice· Unlimited practice on eligible plans
- PYQs with solutions
- Attempt available previous-year questions, then compare your reasoning with the worked solution. Coverage varies by stream.
- Practice that adapts
- Choose a topic, work on weaker areas and bookmark questions to revisit. Your attempts feed your progress tracking.
- AI doubt support
- Ask follow-up questions about a step or concept while practising, instead of stopping at the final answer.
Unlimited practice is available on eligible plans. Free practice and AI usage have limits; check the current plan allowances before choosing.
This page stays readable without an account. AI responses can be wrong; check them against the solution and source material.
More questions on Metrology & Inspection
2026 Set 1 Q31Which one of the following options is NOT an error associated with STereoLithography (STL) file…2026 Set 1 Q33A two-dimensional surface profile is obtained over a sampling length by using a contact type stylus…2026 Set 1 Q45Consider the Euler variables of polyhedral objects namely, , , , and as given in…2025 Set 1 Q23In computer aided design (CAD), solid models can be constructed using2025 Set 1 Q25When assembled, the hole mm and shaft mm will result…