GATE CE 2014 Set 1 — Question 20
Go beyond PYQs with Success TrackerAI-powered personalised practice and doubt support. Unlimited practice on eligible plans; AI usage limits apply.MCQ+1 / -0.33EasyDesign of BeamsSteel Member DesignStructural EngineeringLimit State Design
Structural Engineering → Steel Member Design → Design of Beams
Last updated
Question
A steel section is subjected to a combination of shear and bending actions. The applied shear force is and the shear capacity of the section is . For such a section, high shear force (as per IS:800-2007) is defined as
Correct answer
(A) V 0.6Vₛ
Solution
According to IS 800:2007, Clause 9.2.2, a section is considered to be subjected to 'high shear' when the design shear force exceeds of the design shear strength (or ). In such cases, the reduction in moment capacity due to the presence of high shear must be accounted for.
Continue learning with Success Tracker
A step still unclear? Work through it with support
Use Success Tracker to ask about the reasoning, then try another GATE CE question to check your understanding.
AI-powered practice· Unlimited practice on eligible plans
- PYQs with solutions
- Attempt available previous-year questions, then compare your reasoning with the worked solution. Coverage varies by stream.
- Practice that adapts
- Choose a topic, work on weaker areas and bookmark questions to revisit. Your attempts feed your progress tracking.
- AI doubt support
- Ask follow-up questions about a step or concept while practising, instead of stopping at the final answer.
Unlimited practice is available on eligible plans. Free practice and AI usage have limits; check the current plan allowances before choosing.
This page stays readable without an account. AI responses can be wrong; check them against the solution and source material.
More questions on Steel Member Design
2026 Set 1 Q13A thin-walled spherical gas balloon of radius and wall thickness () is subjected…2026 Set 2 Q14A rectangular singly reinforced concrete beam has a width of 300 mm and an effective depth of 550…2026 Set 1 Q14Black dot shown in the figure qualitatively represents the shear centre of the angle section. The…2026 Set 2 Q15As per IS:800-2007, design of a cantilever steel beam section for its moment capacity requires…2026 Set 1 Q15Which one of the following is utilized to determine the long-term deformation of concrete under…