GATE CE 2014 Set 1 — Question 22
Go beyond PYQs with Success TrackerAI-powered personalised practice and doubt support. Unlimited practice on eligible plans; AI usage limits apply.MCQ+1 / -0.33EasyInfluence LinesIndeterminate Analysis & Influence LinesStructural Engineering
Structural Engineering → Indeterminate Analysis & Influence Lines → Influence Lines
Last updated
Question
In a beam of length , four possible influence line diagrams for shear force at a section located at a distance of from the left end support (marked as P, Q, R and S) are shown below. The correct influence line diagram is
Correct answer
(A) P
Solution
For a section at distance from the left support in a simply supported beam of length , the Influence Line Diagram (ILD) for shear force is defined as:
- For :
- For :
- Just to the left of the section ():
- Just to the right of the section ():
Continue learning with Success Tracker
A step still unclear? Work through it with support
Use Success Tracker to ask about the reasoning, then try another GATE CE question to check your understanding.
AI-powered practice· Unlimited practice on eligible plans
- PYQs with solutions
- Attempt available previous-year questions, then compare your reasoning with the worked solution. Coverage varies by stream.
- Practice that adapts
- Choose a topic, work on weaker areas and bookmark questions to revisit. Your attempts feed your progress tracking.
- AI doubt support
- Ask follow-up questions about a step or concept while practising, instead of stopping at the final answer.
Unlimited practice is available on eligible plans. Free practice and AI usage have limits; check the current plan allowances before choosing.
This page stays readable without an account. AI responses can be wrong; check them against the solution and source material.
More questions on Indeterminate Analysis & Influence Lines
2026 Set 1 Q13A thin-walled spherical gas balloon of radius and wall thickness () is subjected…2026 Set 2 Q14A rectangular singly reinforced concrete beam has a width of 300 mm and an effective depth of 550…2026 Set 1 Q14Black dot shown in the figure qualitatively represents the shear centre of the angle section. The…2026 Set 2 Q15As per IS:800-2007, design of a cantilever steel beam section for its moment capacity requires…2026 Set 1 Q15Which one of the following is utilized to determine the long-term deformation of concrete under…