GATE CE 2018 Set 1 — Question 29
Go beyond PYQs with Success TrackerAI-powered personalised practice and doubt support. Unlimited practice on eligible plans; AI usage limits apply.NAT+1 / -0MediumWelded ConnectionsConnections & Plastic AnalysisStructural EngineeringBolt & Weld Strength
Structural Engineering → Connections & Plastic Analysis → Bolt & Weld Strength
Last updated
Question
In a fillet weld, the direct shear stress and bending tensile stress are and , respectively. As per IS 800: 2007, the equivalent stress (in MPa, up to two decimal places) will be ______
Correct answer
173.1 to 173.3
Solution
According to IS 800: 2007, the equivalent stress for a fillet weld subjected to combined bending and shear is given by:where:
Substituting the values:Rounding to two decimal places, the equivalent stress is .
Substituting the values:Rounding to two decimal places, the equivalent stress is .
Continue learning with Success Tracker
A step still unclear? Work through it with support
Use Success Tracker to ask about the reasoning, then try another GATE CE question to check your understanding.
AI-powered practice· Unlimited practice on eligible plans
- PYQs with solutions
- Attempt available previous-year questions, then compare your reasoning with the worked solution. Coverage varies by stream.
- Practice that adapts
- Choose a topic, work on weaker areas and bookmark questions to revisit. Your attempts feed your progress tracking.
- AI doubt support
- Ask follow-up questions about a step or concept while practising, instead of stopping at the final answer.
Unlimited practice is available on eligible plans. Free practice and AI usage have limits; check the current plan allowances before choosing.
This page stays readable without an account. AI responses can be wrong; check them against the solution and source material.
More questions on Connections & Plastic Analysis
2026 Set 1 Q13A thin-walled spherical gas balloon of radius and wall thickness () is subjected…2026 Set 2 Q14A rectangular singly reinforced concrete beam has a width of 300 mm and an effective depth of 550…2026 Set 1 Q14Black dot shown in the figure qualitatively represents the shear centre of the angle section. The…2026 Set 2 Q15As per IS:800-2007, design of a cantilever steel beam section for its moment capacity requires…2026 Set 1 Q15Which one of the following is utilized to determine the long-term deformation of concrete under…