GATE EE 2017 Set 1 — Question 35
Go beyond PYQs with Success TrackerAI-powered personalised practice and doubt support. Unlimited practice on eligible plans; AI usage limits apply.MCQ+2 / -0.67MediumIdeal & Non-Ideal Op-AmpOperational AmplifiersAnalog & Digital ElectronicsRectifiers (HW, FW, Bridge)Diode Circuits
Analog & Digital Electronics → Diode Circuits → Ideal & Non-Ideal Op-Amp
Last updated
Question
The approximate transfer characteristic for the circuit shown below with an ideal operational amplifier and diode will be
Correct answer
(A) [figure]
Solution
The circuit is a non-inverting precision half-wave rectifier.
1.Case : The op-amp output tries to go positive, forward-biasing the diode . The feedback loop closes, and due to virtual short, . Since is connected to the inverting terminal, .
2.Case : The op-amp output tries to go negative, reverse-biasing the diode . The feedback loop is broken. The output is pulled to ground through the resistor , so .
This behavior matches the transfer characteristic in graph (A).Continue learning with Success Tracker
A step still unclear? Work through it with support
Use Success Tracker to ask about the reasoning, then try another GATE EE question to check your understanding.
AI-powered practice· Unlimited practice on eligible plans
- PYQs with solutions
- Attempt available previous-year questions, then compare your reasoning with the worked solution. Coverage varies by stream.
- Practice that adapts
- Choose a topic, work on weaker areas and bookmark questions to revisit. Your attempts feed your progress tracking.
- AI doubt support
- Ask follow-up questions about a step or concept while practising, instead of stopping at the final answer.
Unlimited practice is available on eligible plans. Free practice and AI usage have limits; check the current plan allowances before choosing.
This page stays readable without an account. AI responses can be wrong; check them against the solution and source material.
More questions on Diode Circuits
2026 Set 1 Q33In the linear regulator circuit shown, the base to emitter voltage of the BJT is…2026 Set 1 Q37In the circuit shown, the open loop gain of the operational amplifier is . What is the…2026 Set 1 Q45The digital circuit shown has 3 inputs (, , and ). [figure] The simplified logical…2026 Set 1 Q46The MOSFET switches shown in the circuit are ideal. [figure] Which of the following is the correct…2026 Set 1 Q61Consider the circuit shown. Assume that the diode () is ideal. Given …