GATE CE 2020 Set 2 — Question 29
Go beyond PYQs with Success TrackerAI-powered personalised practice and doubt support. Unlimited practice on eligible plans; AI usage limits apply.NAT+1 / -0EasyShort-Term PropertiesConstruction MaterialsStructural Engineering
Structural Engineering → Construction Materials → Short-Term Properties
Last updated
Question
The maximum applied load on a cylindrical concrete specimen of diameter and length tested as per the split tensile strength test guidelines of IS 5816:1999 is . The split tensile strength (in MPa, round off to one decimal place) of the specimen is ________.
Correct answer
2 to 2.4
Solution
The split tensile strength of a cylindrical specimen is calculated using the formula:Where:
- is the maximum applied load
- is the diameter of the specimen
- is the length of the specimen
Continue learning with Success Tracker
A step still unclear? Work through it with support
Use Success Tracker to ask about the reasoning, then try another GATE CE question to check your understanding.
AI-powered practice· Unlimited practice on eligible plans
- PYQs with solutions
- Attempt available previous-year questions, then compare your reasoning with the worked solution. Coverage varies by stream.
- Practice that adapts
- Choose a topic, work on weaker areas and bookmark questions to revisit. Your attempts feed your progress tracking.
- AI doubt support
- Ask follow-up questions about a step or concept while practising, instead of stopping at the final answer.
Unlimited practice is available on eligible plans. Free practice and AI usage have limits; check the current plan allowances before choosing.
This page stays readable without an account. AI responses can be wrong; check them against the solution and source material.
More questions on Construction Materials
2026 Set 1 Q13A thin-walled spherical gas balloon of radius and wall thickness () is subjected…2026 Set 2 Q14A rectangular singly reinforced concrete beam has a width of 300 mm and an effective depth of 550…2026 Set 1 Q14Black dot shown in the figure qualitatively represents the shear centre of the angle section. The…2026 Set 2 Q15As per IS:800-2007, design of a cantilever steel beam section for its moment capacity requires…2026 Set 1 Q15Which one of the following is utilized to determine the long-term deformation of concrete under…