Success TrackerSuccess Tracker
Log inSign up

GATE EC 2019 Set 1 — Question 34

Go beyond PYQs with Success TrackerAI-powered personalised practice and doubt support. Unlimited practice on eligible plans; AI usage limits apply.
NAT+1 / -0MediumClipping CircuitsDiode CircuitsAnalog Circuits

Analog Circuits → Diode Circuits → Clipping Circuits

Last updated

Question

In the circuit shown, VsV_s is a square wave of period TT with maximum and minimum values of 88 V and −10-10 V, respectively. Assume that the diode is ideal and R1=R2=50 ΩR_1 = R_2 = 50\ \Omega. The average value of VLV_L is _______ volts (rounded off to 1 decimal place).
Circuit diagram with a square wave source Vs, a resistor R1 in parallel with a diode, and a resistor R2 across which VL is measured. Also shows the waveform of Vs.
Your answer

Enter a number. Decimals, negative values and scientific notation are accepted.

The solution stays hidden until you check.

Continue learning with Success Tracker

A step still unclear? Work through it with support

Use Success Tracker to ask about the reasoning, then try another GATE EC question to check your understanding.

AI-powered practice· Unlimited practice on eligible plans
PYQs with solutions
Attempt available previous-year questions, then compare your reasoning with the worked solution. Coverage varies by stream.
Practice that adapts
Choose a topic, work on weaker areas and bookmark questions to revisit. Your attempts feed your progress tracking.
AI doubt support
Ask follow-up questions about a step or concept while practising, instead of stopping at the final answer.

Unlimited practice is available on eligible plans. Free practice and AI usage have limits; check the current plan allowances before choosing.

Start with a free accountView plans and allowances

This page stays readable without an account. AI responses can be wrong; check them against the solution and source material.

More questions on Diode Circuits

2026 Set 1 Q17The ideal OP-AMP circuit shown in the Figure produces output voltage Vo=xV_o = x when the Switch, S,…2026 Set 1 Q18Consider the circuit shown in the Figure with Vi=3 VV_i = 3\text{ V} and VCC=12 VV_{CC} = 12\text{ V}. Assume…2026 Set 1 Q50A small signal source, Vi(t)=Acos⁡(105t)+Bsin⁡(107t)V_i(t) = A \cos(10^5 t) + B \sin(10^7 t) is applied to a BJT circuit as…2026 Set 1 Q53A circuit using an ideal OP-AMP is shown in the Figure. Which of the following options gives the…2026 Set 1 Q60An nn-channel MOSFET is connected as shown in the Figure. Assume VTH=1 VV_{TH} = 1\text{ V},…